A Phoenix Mecano Company

NIMpact 300W with fan tray

NIMpact crates are low cost crates that meet EUR4100 and CE specifications. They are outfitted with a 300W power supply with over load and over temperature protection. 5U NIMpact crates are with fan tray.

Main features

  • Fully wired 12 slot crate, 19” x 7U (with fan tray)
  • Simplified control panel with On/Off switch and status LED
  • Fan tray with 3 DC fans for cooling,  front or bottom air inlet
  • Integrated linear regulated 300W power supply
  • AC input 230V/50 Hz or 110V/60Hz

 

  • Fully wired 12 slot crate, 19” x  7U
  • Stabilized steel card guide structure
  • Simplified control panel with On/Off switch and status LED
  • Bin equipped with long-life NIM connectors, all lines wired according to CERN or CE specifications
  • Fan tray with 3 DC fans for cooling,  front or bottom air inlet
  • Integrated linear regulated 300W power supply
  • AC input 230V/50 Hz or 110V/60Hz
  • Dimensions: 19" (483mm) x 7U (311.2mm)  x 518mm [whd], weight: ca. 26Kg
  • CE Conformity

Standard Crate configurations (other possible on request)

Type +6V/-6V +12V/-12V +24V/-24V 115V AC Type / Power
NIMpact I23 L_x  11.5A / 11.5A 3.4A / 3.4A 3.4A / 3.4A 0.5A UEP24 / 300W
NIMpact I24 L_x 15A / 15A  3.4A / 3.4A 3.4A / 3.4A 0.5A UEP24 / 300W
NIMpact I26 L_x 7A / 7A 15A / 15A - 0.5A UEP24 / 300W
NIMpact I27 L_x 8.6A / 8.6A 3.4A / 3.4A 6.9A / 6.9A 0.5A UEP24 / 300W


Note:    _x = defines the AC input voltage, factory default  is 220V AC (without index)
                          x = B:     110V AC
                          x = J:      100V AC
                          x = E:     240V AC

 

NIMpact NIM Bin 7U

Ventilated 518mm deep 7U NIM bin with 12 slot. Aluminum construction with stabilized steel card guide structure. Power supply is fixed mounted rear side. For improved cooling a 2U high fan tray with 3 DC fans is mounted below the card cage.

The power-bus-system is equipped with 12 high-quality long-life NIM connectors on a power backplane. Connector pins made of massive brass, gold plated.
Simplified ½ slot wide control panel with on/off switch and status LED.

Current maximum ratings:

Voltage Line Current / slot Current / bin Comment
+/-6V 13A 65A sensed
+/-12V 13A 13A sensed
+/-24V 13A 13A sensed
GND 13    
115V AC - 0.5A Secondary

All NIM bins have clean earth wired with 0,25mm²

UEP 24 300W NIMPact Power Supply

Linear regulated low noise power supply with 300W DC output, cut-off-protection for “overload” and “over temperature”-failures.

Power supply DC-Outputs: +6V -6V +12V -12V +24
UEP24_I23 11.5A 11.5A 3.4A 3.4A 3.4A
UEP24_I24 15A 15A 3.4A 3.4A 3.4A
UEP24_I26 7A 7A 15A 15A -
UEP24_I27 8.6A 8.6A 3.4A 3.4A 6.9A

 

Power supply DC-Outputs: -24V 115VAC max. power regulation application
UEP24_I23 3,4A 0.5A 300W linear NIM 
UEP24_I24 3,4A 0.5A 300W linear NIM 
UEP24_I26 - 0.5A 300W linear NIM 
UEP24_I27 6,9A 0.5A 300W linear NIM 

 

UEP 24  
Input voltage, 47-63Hz 100V(+/-10%) , 115V or 230V
Soft start yes
Output: Noise and Ripple: Full load / 80% rated output  <3mVpp / 1mVpp,  <0,6mVRMS
Regulation static: Change of output voltage versus load change 10-100% <0,05%
Regulation static: change of output voltage versus line change  +/-10% <0,02%
Recovery time versus load change 10-100% <0,15ms
Output impedance:  Static / Dynamic(at 100kHz) 0,2mOhm / 0,5 Ohm
Temperature Error <0,005%/K
Thermal Protection (No. of thermal switches) (3x)
Output Current Characteristics (Ishort <3A in foldback regulators), reverse bias diodes! Foldback and trip off
Dual tracking for complementary outputs yes
Calibration ranges Voltage / Currents +/-5% / 20%
Sense compensation  ranges, all DC voltages  0,5V
Status Control for all voltages (Over- Under-Voltage Comparator, defaults +/-0,3%) bad/good, Status LED-signal
Overvoltage Protection, trip off thresholds (defaults) Crow bars  7,3V, 14,5V, 24,5V
Derating >40°C with 2% up to 60°C max.

Optional CAN-bus interface for DC voltage monitoring and remote on/off via rear 9 pin sub D connector

 

Product Data Sheet  
NIMpact 300W with fan tray: Print Product Data Sheet

 

Documentation  
Manual and Tech-Notes : Manual_NIM-CAMAC
Introduction: WIENER_NIM_CAMAC_ introduction

 

Product Finder

Use our new product finder to locate any item.

Submit