UEP10M52 / CEP10M52 - CAMAC Power Supply 650W

The UEP10M52 series is a UEP10M variation with a maximum current output on +6V (asymmetric) and without +/-12V for use in CERN type CAMAC crates with a maximum 650W power output.

The power supply has all the standard features of the UEP10 family as high precision and lowest noise DC outputs and a cut-off protection for overload, over- / and undervoltage and overtemperature failures. The high power density and excellent electrical characteristics are achieved by the "Energy tank technology", a special filter and storage capacitor bank assembly with low internal resistance and non inductive bonding.

The power supply is outfitted with alarming and monitoring facilities according to CERN CAMAC Note 46-04. The signals are wired on the control- and monitoring connector (15-pin sub-D / PG 27+28) and provide a status output ("good" when all DC-voltages within tolerance level), rearming input, power fail signal as well as alarms for overload and overtemperature, voltage and current monitor outputs.

The CEP10M52 is the CE conform version with separate AC wiring.

Technical Data

Dimensions:	width 429 mm, height 172 mm, depth 215 mm
Weight:	17.6 kg
Mains Input :	100 +/-10% / 115 / 230 VAC +10-15%, 48 - 63 Hz
Inrush current:	limited to < 15A, 30A /115V mains filter, fuse protection
Derating:	full power at 50°C, derating 2 %/K up to 60°C
Regulation:	load 10 to 100% Uout < 0.05% line +/-10 Uout < 0.02%
Recovery time :	load change 10 % to 100%: < 0.15ms
Sense compens.range:	min. 0.5V
Noise and ripple:	full load < 0.6mVeff, < 3mVpp, at 80% rated power <1mVpp
Temperature error:	< 2*10-4 /K
Thermal protection:	overheating protection by thermal switches(3 fold)
Current characteristics:	current limit adjusted to 115% rated current, adjusting range +/- 20 %, short circuit protected by fold back characteristic, short circuit current < 3A, reverse bias diodes.
Voltage characteristics:	calibration range +/- 5 % rated voltage, dual tracking for all +/-DC-Outputs, overvoltage protection (crow bar)

Standard power supply versions (other possible on request)

Type	+6V	-6V	+12V	-12V	+24V	-24V	115VAC
UEP 10M52	65A	32A	-	-	8A	8A	0.5A
CEP10M52 [CE conform]	65A	32A	-	-	8A	8A	0.5A