CAMAC -  “Computer Aided Measurement And Control” is a joint specifications of the U.S. NIM and the European ESONE committees. CAMAC was introduced in 1969 by ESONE and fully defined in 1971 with the standards  EUR4100 and EUR4600. It represents a complementation of the NIM standard for computer based experiment control and data acquisition / measurements. Main field of CAMAC use are computer controlled control and data acquisition systems in nuclear and high energy physics experiments but also industrial applications in the past. CAMAC modules have half of NIM width and are outfitted with a rear side 86-pin edge card connector. Module power, address bus, control bus and data bus are provided by the CAMAC Dataway which includes 48 digital data transfer lines (24 read, 24 write), strobe signal lines as well as address and control lines. CAMAC crates for 19” rack mounting have 25 slots. Station 25, the rightmost station, is reserved for a CAMAC Crate Controller whereas slots 1 to 24 are normal stations. Standard CAMAC crate controllers are double wide and use the two rightmost slots 24 and 25. WIENER offers the following CAMAC crate controllers and modules / accessories: PCICAMAC - CC32 CAMAC crate controller with PCI Interface VMECAMAC  - CC32 CAMAC crate controller with VME Interface CCUSB - CAMAC crate controller with USB interface   Other WIENER CAMAC products: CAMAC crates  CAMAC power supplies blank CAMAC mechanics CAMAC dataways